Installing a Brick Paver Walkway or Bricks Stones

The usage of Bricks or Pavers to create a sidewalk or patio complements a house in a method that is unmatched. In addition, setting up a Brick or Paver walkway does not necessarily need a pro.

The key to installing a Brick or Paver Walkway is to very first correctly prepare the location where the bricks/pavers are to be set up. The area ought to be removed a minimum of a foot down, removing all topsoil and clay soil. In addition, string lines ought to be strung on each side of the pathway. The string lines show the finished height of the pathway.
When the location has actually been dug down, 3/4" gravel stone should be laid in and tamped down tightly. 2" of sand, or stone dust need to be spread out over the gravel. Once again the sand/stone dust need to be tamped down. Stone dust is chosen. The height between the tamped down sand and the stringline should equal the density of the brick or paver.

Now that you have a steady base, position a 1" pipe or ledger board the length of the walkway on either side of the sidewalk. Then utilizing a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will develop a level area to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Set up a work on both sides of the prepared location. These strips will act as your pathway border and assistance to preserve the stability and shape of the walkway. You can get these plastic strip borders at many house improvement stores. The strips ought to be anchored down with 12" galvinized nails. You should sink these nails into the ground and through the strips every foot.

The key to laying the bricks/pavers is to guarantee that they here interlock with each other. Always stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will again assist keep the integrity of the pathway.

Inevitably bricks/pavers will require to be cut or divided when developing the sidewalk. To in fact cut/split the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the area where you want to break the brick. If your sidewalk has curves you will require to buy/rent a wetsaw.

After installing the bricks, develop the outside edges with additional sand, and after that shovel in the topsoil and pack down firmly.
Spread stone dust over the brand-new walkway and sweep into the fractures. This will complete the interlocking of the bricks and assist to eliminate any weed development.


In addition, installing a Brick or Paver sidewalk does not necessarily need a pro. The key to setting up a Brick or Paver Walkway is to first appropriately prepare the location where the bricks/pavers are to be installed. Now that you have a steady base, position a 1" pipeline or journal board the length of the pathway on either side of the walkway. These strips will act as your pathway border and help to preserve the integrity and shape of the sidewalk. Inevitably bricks/pavers will require to be cut or divided when developing the walkway.

Leave a Reply

Your email address will not be published. Required fields are marked *